Troubleshooting; Corrective Action; Warranty - Kobalt KRS 1824B-03 Manual De Instrucciones

TROUBLESHOOTING

WARNING
• Turn the switch to the "OFF" position, press the switch lock button to lock it and remove the
battery pack from the reciprocating saw before performing troubleshooting procedures.
PROBLEM
The reciprocating
saw does not work.
Blade binds, jams, or
burns the wood.
Blade cannot be
removed.
Saw vibrates or
shakes.
The LED worklight
blinks rapidly.
The LED worklight
blinks slowly.

WARRANTY

For 5 years from the date of purchase, the reciprocating saw is warranted for the original
purchaser to be free from defects in material and workmanship. This guarantee does not
cover damage due to abuse, normal wear, improper maintenance, neglect, unauthorized
repair/alteration, or expendable parts and accessories expected to become unusable after a
reasonable period of use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
Battery is depleted.
1. Improper operation .
2. Dull blade.
3. Improper blade.
Saw dust in the blade
clamp slot.
1. Damaged blade.
2. Loose blade.
The tool has stopped
working to protect internal
circuits.
The battery charge is very
low.

CORRECTIVE ACTION

Charge the battery.
1. See "OPERATING
INSTRUCTIONS" section.
2. Replace or sharpen blade.
3. Replace blade.
Clean the clamp slot with brush.
1. Replace blade.
2. Remove the blade and reinstall it.
Release the trigger switch, wait for
the tool to cool down, then start the
tool again.
Charge the battery.
15