Troubleshooting; Corrective Action; Warranty - Kobalt KRS 124B-03 Manual De Instrucciones

TROUBLESHOOTING

WARNING
• Engage the switch-lock button (E) and remove battery from the tool before performing
troubleshooting procedures.
PROBLEM
Tool does not work.
Blade binds, jams,
or burns the wood.
The motor is
overheating.
The LED worklight
blinks rapidly.
The LED worklight
blinks slowly.

WARRANTY

For 5 years from the date of purchase, the power tool is warranted for the original purchaser
to be free from defects in material and workmanship. This guarantee does not cover damage
due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specific legal rights, and you may also have other rights
that vary from state to state.
POSSIBLE CAUSE
Low battery capacity.
1. Improper operation.
2. Dull blade.
3. Improper blade.
Cooling vents are
obstructed.
The tool or battery is too
warm, and the tool has
stopped working to protect
internal circuits.
The battery charge is very
low.

CORRECTIVE ACTION

Charge the battery pack.
1. See "OPERATING INSTRUCTIONS"
section.
2. Replace or sharpen blade.
3. Replace blade.
Clean and clear the vents. Do not
cover the vents with your hand during
operation.
Release the variable-speed trigger
switch (D), wait for the tool to cool down,
then start the tool again.
Charge the battery.
L G Sourcing, Inc., N. Wilkesboro, NC 28659
14
Printed in China