Fitting The Carrying Cord; Inserting And Changing The Battery - Leica PINMASTER II PRO Instrucciones

FITTING THE CARRYING CORD

Push the small loop of the carrying cord through the
4
eyelet on the housing of the Leica Pinmaster II Pro.
Then, thread the end of the carrying strap through the
small loop and pull it tight so that the loop that is
formed is securely attached to the eyelet on the
housing.
Open
Closed

INSERTING AND CHANGING THE BATTERY

The Leica Pinmaster II Pro is supplied with power by
one 3 Volt lithium cell (e.g. Duracell DL CR 2, Ucar CR
2, Varta CR 2, or other CR 2 types).
6
1. Open the cover of the battery compartment
by turning it anticlockwise.
2. Insert the battery with the plus (+) contact facing
forwards (as indicated by the mark in the battery
compartment).
3. Close the cover again by turning in clockwise
direction.
EN
7
21