Care/Cleaning; Spare Parts - Leica PINMASTER II PRO Instrucciones

EN
CARE / CLEANING
Your Leica Pinmaster II Pro does not require any special
care. Any large dirt particles, such as sand, should be
removed with a soft brush or blown off. Fingerprints,
etc. on lenses and eyepieces can be pre-cleaned using
a damp cloth and then wiped off using a soft, clean
leather or lint-free cloth.
Important:
Do not apply excessive pressure when cleaning heavily
soiled lens surfaces. Although the coating is highly
abrasion-resistant, it can nevertheless be damaged by
sand or salt crystals.
The housing should only be cleaned using a damp
piece of leather. There is a risk of static charges if dry
cloths are used.
Alcohol and other chemical solutions must not be used
for cleaning the lens or the housing. In addition to the
designation by type, each Leica Pinmaster II Pro has an
individual serial number. Please note this number in
your documents as a safety measure.
30
Attention:
Do not open the unit under any circumstances!

SPARE PARTS

Should you require spare parts for your Leica
Pinmaster II Pro, e.g. eyecups or carrying strap, please
contact our Customer Services or your national Leica
agency (see the warranty card for a list of addresses).