Desoutter EAP2-65-TF Serie Manual Del Usuario página 21

Error Description
E512 Reading error of "Code - Station - Sequence - Cycle" parameter
E513 Reading error of "Maintenance" parameters
E514 Writing error of STATION parameter
E515 Writing error of ACCESS CODE parameter
E516 Writing error of CYCLE parameter
E517 Writing error of SEQUENCE parameter
E519 Writing error of the error table
E521 Writing error of the cycle manually set up
E524 Software version
E525 Writing error of CALIBRATION parameters
E526 Writing error of the torque coefficient
E527 Writing error of linearity table
E528 Writing error of motor offset coefficients
E529 Writing error of CRC on "Identification - Tool - Calibration" parameters.
E530 Writing error of CRC on "Code - Station - Sequence - Cycle" parameters
E531 Writing error of CRC on "Maintenance" parameters
E532 Writing error of the tool option
E533 Writing error of the tool type
E534 Writing error of approach torque
E536 Writing error of the error table
E666 Error in the linearity table.
E667 Error seeking zero position.
E668 Error seeking
according to speed.
EAP-TFlex tools
ERROR TABLE
This error can only appear at the end of the first phase of the engine
tuning. It could be an engine problem, it could be a magnet problem in
the engine shaft extension, the power module or the DSP board. Contact
our customer service.
This error can only appear after the second phase of the engine tuning.
This can be a problem with the magnet in the engine shaft extension, or a
problem on the hall board. Contact our customer service.
offset evolution This error can only appear at the end of the third phase of the engine
tuning. This can be a problem with the magnet in the engine shaft
extension, or a problem on the hall board. Contact our customer service.
Part no
Issue no
Language English
Date
Page
Checking/Actions
6159932890
02
01/2010
166
21 /