Operator Interface - Desoutter EAP2-65-TF Serie Manual Del Usuario

Part no 6159932890
Issue no 02
Language English
Date 01/2010
166
Page 8 /

4.2 - Operator interface

Description
Modifying the direction of rotation.
When
enabled, the lights are off. When the run
Direction of
reverse direction is enabled, the red and
rotation
green lights are flashing.
Entering the programming mode and
validating.
Programming
button
Changing a parameter: increasing the
value of a parameter or toggling values.
Button +
Changing a parameter: decreasing the
value of a parameter or toggling values.
Button -
Showing that the number of cycles is
higher than the number programmed
and that it is time to perform control or
Maintenance
maintenance operations.
LED
In the Advanced Programming mode,
showing that the access code can be
Access code LED
modified between 0 and 999.
When starting any programming mode,
showing that an access code must be
entered.
In the
showing that the torque can be changed.
In the Advanced Programming mode,
Torque LED
showing that the Torque Preset mode is
selected or that the unit must be selected
(Nm / FtLb / InLb).
In the control mode, showing that the
Data Recording mode is activated.
Result recording
In the Advanced Programming mode,
LED
showing that the Data Recording menu
is selected.
In the Advanced Programming mode,
showing that the Calibration mode is
selected.
Calibration LED
DESCRIPTION AND OPERATION
Function
the tightening direction
Easy Programming mode,
EAP-TFlex tools
Description
is
Communication
LED
Display
+
Function
Showing that the
communication between the tool and the
specific CVIPFlex software is active
(see CVIPFlex software manual).
Displaying the tightening reports (OK,
NOK, tightening faults,
errors) and the main parameters of the
tool.
Entering the Advanced Programming
mode: press these two
simultaneously, starting with
3s (see "PROGRAMMING", page 10).
bluetooth
operating
buttons
, during