Iso Din Radio Provision With Pocket - Metra 99-5823CH Instrucciones De Instalación

ISO DIN radio provision
with pocket
1. Remove the metal "DIN"
sleeve and trim ring from the
aftermarket radio.
2. Mount the ISO Brackets to
the radio with the screws
supplied with the radio.
(Figure A)
3. Snap the pocket into the
lower opening of the radio
housing. (Figure B)
4. Slide the radio into the upper
opening of the radio housing
until the side clips engage.
(Figure B)
5. Snap the ISO trim plate into
the Radio Housing. (Figure C)
Kit Assembly
(Figure A)
(Figure B)
®
99-5823CH
6. Connect the climate extension
harness to the climate control
harness removed in step 2
of disassembly, and then into
the 99-5823CH radio/climate
panel.
7. Locate the factory wiring
harness in the dash. Metra
recommends using the proper
mating adapters from Metra
and AXXESS to integrate your
new radio. Re-connect the
negative battery terminal
and test the radio for proper
operation.
8. Reassemble the dash in
reverse order of disassembly
using the 99-5823CH radio/
climate panel instead of the
factory radio trim panel.
4
(Figure C)