Transport, Storage And Disposal - Madas EVAP/NA Manual De Instrucciones

Max P.
DN
(bar)
15-20-25 0.36
15-20-25 1-3-6
32-40-50 1-3-6

7.0 - TRANSPORT, STORAGE AND DISPOSAL

• During transport the material needs to be handled with care, avoiding any impact or vibrations to the device;
• If the product has any surface treatments (e.g. painting, cataphoresis, etc), it must not be damaged during transport;
• The transport and storage temperatures must observe the values provided on the rating plate;
• If the device is not installed immediately after delivery, it must be correctly placed in storage in a dry and clean place;
• In humid facilities, it is necessary to use driers or heating to avoid condensation.
• At the end of its service life, the product must be disposed of in compliance with the legislation in force in the country where
this operation is performed.
8.0 - WARRANTY
The warranty conditions agreed with the manufacturer at the time of the supply apply.
Damage caused by:
• Misuse of the device;
• Failure to comply with the requirements set out in this document;
• Failure to observe the regulations pertaining to installation;
the rights of the warranty or compensation for damage cannot be claimed.
The warranty also excludes maintenance work, the assembly of parts or non-original spare parts, making changes to the
device and natural wear.
9.0 - RATING PLATE DATA
The rating plate data (see example provided here) includes the following:
• Manufacturer's name/logo and address (possible distributor name/logo)
• Mod.: = device name/model followed
by the connection diameter
• P. max = Maximum pressure at which product operation is guaranteed
• PS = Allowable maximum pressure
• IP.... = Protection rating
• 230V.... = Power supply voltage, frequency (if Vac), followed by the electrical absorption
Example of electrical absorption indication: 55/16 VA indicates 55 VA at start, 16 VA at steady state
• TS = Temperature range within which product operation is guaranteed
• = Compliance with PED directive followed by the no. of the Notified Body
• year = Year of manufacture
• Lot = Product serial number (see explanation below)
• U1804 = Lot issued in 2018 in the 4
• 2185 = progressive job order number for the indicated year
• 00001 = progressive number referring to the quantity of the lot
EVAP/NA - EVAP-1-3-6/NA - EVA-1-3-6/NA
CPI/OPI feasibility
Set-up
CPI
OPI and CPI+OPI versions can only be supplied from the factory.
For these 2 versions, the version with set-up is not envisaged.
week
th
CPI
Mod.: EVA-1/NA DN 50
IP65 - 230 V/50-60 Hz 55/16 VA
year: 2018
14
Madas Technical Manual - 1|1.7 - REV. 0 of 10
OPI CPI + OPI
P.max=PS= 1 bar
TS: -20+60 °C
Lot:U1804 2185/00001
Oct 2019
th
0497