Final Installation - Harbor Breeze TM52BNK5CS Manual Del Usuario

WIRING (continued from previous page)
2. Connect green wire from downrod (A) to green wire on mounting
bracket (C). [Fig. 2]
3. Strip 3/4 of an inch of insulation from ends of white wire. Twist
stripped ends of each strand of wire within the insulation with
pliers. [Fig. 3] Snip ends after twisting strands together. Repeat for
black, blue (if applicable) and green wires.
4. Screw wire connectors (P) on in a clockwise direction. Wrap
electrical tape around each wire connector (P) down to the wire as
shown in Fig. 4.
WARNING: Make sure no bare wire or wire strands are
visible after making connections. Place green and white connections
on opposite side of box from the black and blue (if applicable)
connections.
Turn spliced/taped wires upward and gently push wires and wire
connectors (P) into outlet box.
FINAL INSTALLATION (continued on next page)
1. Locate two canopy mounting screws (Q) on underside of mounting
bracket (C) and remove canopy mounting screw (Q) closest to the
open end of the hanging bracket (C). Partially loosen the other canopy
mounting screw (Q). Lift canopy (B) to mounting bracket (C). Place
rounded part of slotted hole in canopy (B) over loosened canopy
mounting screw (Q) in hanging bracket (C) and push up. Twist canopy
(B) to lock. Re-insert canopy mounting screw (Q) that was removed,
and then tighten both canopy mounting screws (Q) securely. Slide
canopy cover (U) up to canopy (B), aligning rounded part of slotted
holes in canopy cover (U) with screwheads in bottom of canopy (B).
Turn canopy cover (U) to the right (clockwise) until it stops. [Fig. 1]
2. Position blade arm (H) under blade (I) and attach blade arm (H)
to blade (I) with blade screws (L) and blade washers (O). Do not
tighten blade screws (L) until each blade screw (L) has been
started. Then, tighten each blade screw (L) starting with the one in
the middle. [Fig. 2] Repeat for the remaining blades (I).
3. Insert only one motor screw (K), with lock washer (N), through
blade arm (H) to attach blade arm (H) to motor and partially tighten
motor screw (K). [Fig. 3] Repeat with remaining blade arms (H).
4. Insert remaining motor screws (K) with lock washers (N). [Fig. 4]
Tighten all motor screws (K) securely.
5. Partially loosen two screws on fitter plate on underside of motor
and remove the other screw. Align slotted holes in switch housing
plate (G) with loosened screws on fitter plate. Twist switch housing
plate(G) to lock. Re-insert the screw that was removed and securely
tighten all three screws. [Fig. 5]
Fig. 2
Fig. 3
Fig. 4
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
7
B
A
P
P
P
B
Q
U
A
L
O
H
D
N
K
H
D
H
I
Fitter Plate
G
I
D