Fan Operation; Important - Harbor Breeze TM52BNK5CS Manual Del Usuario

FINAL INSTALLATION (continued from previous page)
6. Remove three screws from outer edge of switch housing plate (G).
Connect male plug from motor housing (D) to female plug from light
kit fitter (E). Make sure that they are securely connected. Attach light
kit fitter (E) to switch housing plate (G) with the three screws that
were removed. [Fig. 6]
7. Align dimples on socket cover with grooves in glass shade (J).
Turn glass shade (J) clockwise to secure. [Fig. 7] Repeat with the
other glass shades (J).
8. Install four candelabra base 40 watt bulbs (M) included. [Fig. 8]
Important: When replacing bulbs, allow bulb(s) and light kit to cool
before touching them.
Pull chain extensions (T) supplied in one of the hardware packs or
custom pull chain extensions (sold separately) may be attached to
fan and light pull chains. [Fig. 8]
NOTE: This fan is remote control adaptable (remote control sold
separately.)

FAN OPERATION

1. The fan pull chain, labeled SPEED, has four positions to control
fan speed. One pull is HIGH, two is MEDIUM, three is LOW and
four turns the fan OFF. [Fig. 1]
2. Pull the light pull chain, labeled LIGHT, to turn the lights ON or
OFF. [Fig. 2]
3. Use the fan reverse switch, located on the light kit fitter (E), to
optimize your fan for seasonal performance. [Fig. 3]
Note: Wait for fan to stop before moving the reverse switch.
3A. In warmer weather, counterclockwise movement of the
fan will result in downward airflow creating a wind chill
effect. [Fig. 3A]
3B. In cooler weather, clockwise movement of the fan will
result in upward airflow that can help move stagnant, hot air
off the ceiling area. [Fig. 3B]
IMPORTANT: Reverse switch must be set either completely to
the RIGHT or completely to the LEFT for fan to function. If the
reverse switch is set in the middle position [Fig. 3C], fan will not
operate.
8
D
G
Female
Male
Plug
Plug
E
Socket
Fig. 6
E
Socket
Cover
J
Fig. 7
E
T
Fig. 8
Fig. 1
Fig. 2
E
Fig. 3
Fig. 3A
Fig. 3B
Fig. 3C
M