Nogueira SOFT DUO 1300 Manual De Instrucciones página 121

ƒ After placing the cardan, fasten the chains in a
way that allows the articulation in any working
condition and transportation.
ƒ You must observe the length of the cardan shaft
whenever you use a different tractor model.
ƒ It is the Authorized Dealer sole responsibility to
perform the cardan shaft preparation and the
first activation of the machine.
ƒ After coupling, make sure that the cardan
shaft is properly locked in the machine and
tractor shafts. Release of the cardan shaft
during operation may damage the machine
and cause a serious accident if someone is
struck by it.
ƒ Do not enter the cardan shaft work area while
the machine is in motion, any contact with
the cardan shaft can cause a serious accident.
ƒ Do not wear wide clothes with belts or parts
that may catch on the cardan's moving parts.
ƒ Never use the cardan without its protective
cover.
IMPORTANT!
d
o not work with the cardan shaft with an angle
15 .
o
above
In normal working conditions, with the implement
in its horizontal position and being shifted in a
straight line, the contact surface between the
tube and the bar must be 2/3 of the minimum
length of the cardan.
In a more critic situation, the measure of this
overlap must be at least 1/3 of the minimum
length of the cardan.
CAUTION!
TRACTOR
15
o
15
o
Instructions Manual
4. Preparation
female male
MACHINE
L
2/3 of L
33