Fein Slugger JMU 404 M Serie Instrucciones De Uso página 17

Drill chuck (figure 7)
Loosen both screws of the tool holder using
the hex key.
Insert the drill chuck into the tool holder.
Tighten the two screws of the tool holder
against the surfaces on the shank of the drill
chuck using the hex key.
Drill bit (figure 7)
The knurled nut has a left-hand thread; turn
clockwise to release!
Loosen the knurled nut and remove the tool
holder by applying a hammer blow to the
positioned drift.
Clean the inside cone of the output shaft and
insert the drill bit.
Fig. 7
2. 1.
3.
Drill chuck
5 mm
1.
Knurled
3.
nut
en
6. 4.
4. 6.
5.
6 mm
3.
2.
4.
Drill bit
17
7.
MK 4
MT 4
CM 4