Inserting The Rechargeable Batteries: - Riester uni I econom Instrucciones Para El Uso

− Remove the batteries from the battery handle by holding the opening of the battery handle
slightly downwards and shaking it slightly if necessary.
− Firmly screw the battery handle cover back on.
CAUTION!
For all factory-installed or separately supplied batteries, the red safety foil on the plus side
must be removed before startup!
CAUTION!
Only applies to battery handle (2.5) type C with rheotronic® 3.5 V for charging at a 230 V or
120 V socket:
When using the new ri-accu® L 10692, make sure that no insulation is attached to the
spring of the battery grip cover. When using the old ri-accu® L 10692 insulation must be
attached to the spring (risk of short circuit).
new ri-accu® L
old ri-accu® L

3.2.4 Inserting the rechargeable batteries:

Battery handles (2.3.1) type C with rheostat 1.5 V (for ri-charger®).
Battery handle (2.3.2) type C with rheostat 3.5 V (for ri-charger® L).
Battery handle (2.3.4) type C with rheostat 3.5 V (for plug-in charger).
Battery handle (2.3.3) type C with rheostat 3.5 V for charging in a 230 V or 120 V socket.
CAUTION! Please observe the safety information!
− Unscrew the battery handle cover on the lower part of the handle in a counter-clockwise
direction.
− Remove the red safety foil on the plus side of the battery during initial startup.
− Insert the rechargeable battery approved for your battery grip (see 2.3.1 to 2.3.4) with the
plus side in the direction of the upper part of the handle into the battery handle. In addition
to the plus symbol, you will also find an arrow that shows you the direction of insertion
into the battery grip.
− Firmly screw the battery handle cover back on.
3.3 Charging the battery handles that have rechargeable batteries:
3.3.1 Battery handle (2.3.1) type C with rheostat 2.5 V (for ri-charger®).
− Can only be used in the ri-charger® L charger (art.no. 10700, art.no. 10701) by RIESTER.
− The ri-charger® charger comes with an additional user manual that must be observed.
3.3.1.1 Battery handle (2.3.2) type C with rheostat 3.5 V (for ri-charger® L)
− Can only be used in the ri-charger® L charger (art.no. 10705, part no. 10706) by RIESTER.
− The ri-charger® L charger comes with an additional user manual that must be observed.
3.3.2 Battery handle (2.3.4) type C with rheostat 3.5 V (for plug-in charger)
− It can only be charged with the plug-in charger (art.no. 10707) by RIESTER.
For this purpose, the small round plug at the bottom of the battery handle is plugged into
32