Install Ductwork - Broan best WPD28I Manual Del Usuario

1. INSTALL DUCTWORK

This exhaust hood is designed for use with gas or electric outdoor cooking appliances when operated in an outdoor
covered patio or lanai area. As with all electrical appliances, this unit should be protected from the effects of weather
as much as possible.
This unit is not designed for use with a charcoal grill.
The Best WPD28I model must be installed with the interior blower P12D only (sold separately). Other blowers cannot
be substituted.
Plan where and how the ductwork will be installed.
Install 10" round galvanized steel ductwork, elbows and roof or wall cap for the type of blower you are installing. Use
2" duct tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 30". A maximum of 36" above cooktop is
highly recommended for best capture of cooking impurities.
Run power cable to installation location.
The power cable must be a GFCI protected branch circuit.
ROOF CAP
DECORATIVE
FLUE or SOFFIT
16 5 / " to
16
TOP OF WOOD
MOUNTING STRIP
30" TO 36" ABOVE
COOKING SURFACE
HH0022A
!
!
10" ROUND DUCT
OPTIONAL
9" x 18" to 10"
ROUND TRANSITION
INCLUDED
HOOD
18"
WARNING
WARNING
OPTIONAL
DECORATIVE
FLUE or SOFFIT
9" x 18" to 10" ROUND
TRANSITION INCLUDED
18"
HH0023A
- 4 -
HOOD
5
16 / " to
16
TOP OF WOOD
MOUNTING-STRIP
30" TO 36" ABOVE
COOKING SURFACE
WALL CAP