Symbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch KTS 340 Manual Original

en 20 | KTS 340 | Symbols used
1.

Symbols used

1.1

In the documentation

1.1.1

Warning notices - Structure and meaning

Warning notices warn of dangers to the user or people in
the vicinity. Warning notices also indicate the consequenc-
es of the hazard as well as preventive action. Warning no-
tices have the following structure:
KEY WORD – Nature and source of hazard!
Warning
symbol
Consequences of hazard in the event of fail-
ure to observe action and information given.
¶
Hazard prevention action and information.
The key word indicates the likelihood of occurrence and
the severity of the hazard in the event of non-observance:
Key word Probability of
occurrence
DANGER Immediate impend-
ing danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
1.1.2

Symbols in this documentation

Symbol Designation Explanation
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps.
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible inter-

result mediate result.
Final result There is a visible final result on com-
"
pletion of the instruction.
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible.
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
|
1 689 989 038 2013-08-16
Severity of danger if in-
structions not observed
Death or severe injury
Death or severe injury
Minor injury
2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Bosch
TEST EQUIPMENT". These instructions must be carefully
studied prior to start-up, connection and operation of
the KTS 340 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety in-
structions for Bosch TEST EQUIPMENT". These instruc-
tions must be carefully studied prior to start-up, con-
nection and operation of the KTS 340 and must always
be heeded.
2.3

Electromagnetic compatibility (EMC)

The KTS 340 is a class B product as per EN 61 326.
2.4

Open Source Software

A list of the open source software licenses for the
KTS 340 can be found in an Adobe PDF document on
the "ESI[tronic] Startcenter" DVD.
2.5

Pass-Thru Mode (SAE J2534)

i
The " (Info) >> Help" menu in the Online Help
contains all the necessary information on Pass-Thru
mode.
2.6 R&TTE Directive
The KTS 340 is a class 1 wireless device (R&TTE
1999/55/EC) approved for use in Europe. In France, use
of the KTS 340 is only permissible indoors.
i
In non-European countries the corresponding nation-
al regulations on the operation of wireless devices
in the 2.4 GHz frequency band must be heeded (e.g.
WLAN or Bluetooth).
2.7

Measuring category according to

EN 61010-2-030:2010
EN 61010-1:2010 specifies the general safety require-
ments for electrical testers and measuring devices and
defines the measuring categories from 0 to IV in the
section EN 61010-2-030:2010.
The KTS 340 is intended for use in measuring category
0, i.e. for measurements in circuits with no direct con-
nection to the mains voltage.
Robert Bosch GmbH