Commissioning - Klarstein Hannibal Manual Del Usario

COMMISSIONING

Switch on the device
To turn on the unit, press the power switch on the back of the unit. The display will turn on
briefly and a beep will sound.
Setting the temperature
1 Press the temperature controller. The display turns on and the temperature value
flashes. The preset temperature is 800 °C.
2 Turn the temperature control clockwise to set the temperature to 850 °C. The
display will flash. Turn the temperature control knob counterclockwise to reset the
temperature to 800°C, without pressing the temperature control knob.
3 When you have set the desired temperature, press the thermostat again. The heating
elements begin to heat up and the fan starts. You can now start grilling.
4 If you want to end or stop grilling, press the temperature control button again to
stop the appliance.
Note: If you have finished grilling or have not used the appliance for a long time,
switch it off. Wait until the fan stops running, then unplug the appliance.
Setting the time
• Press the time control knob to start the stopwatch. The time is counted up every
second.
• Press the time control again to stop the stopwatch.
• Press and hold the time control for at least 3 seconds to reset the stopwatch to [0].
• If the stopwatch has run for 1 hour without the appliance being operated manually,
the grill will automatically stop.
Note: If you have finished grilling or have not used the appliance for a long time,
switch it off. Wait until the fan stops running and then unplug the appliance.
EN
27