Preparing The Coating Material - WAGNER W 560 Modo De Empleo

W 560
1) Air Cap
3) Union nut
5) Trigger guard
7) Material volume adjustment
9) Mains lead
11) Ventilating hose
Coating Materials Suitable for Use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes, automotive
finishes, staining sealers and wood sealer-preservatives.
Coating Materials Not Suitable for Use
Wall paints (emulsion paints) etc., alkali and acidic paints. Coating materials with a flash point
below 21°C.

Preparing the Coating Material

The enclosed spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet of
the manufacturer ( Internet download).
1. Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
Paints containing solvents and water-soluble
paints, primers, vehicle coating paints,
thick-film glazes
2. If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements.
Start-up
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
•
Unscrew the container from the spray gun.
•
Aligning suction tube. (Fig. 2)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When working on lying objects: Turn the suction tube forwards. (Fig. 2 A)
Spraying work when working on overhead objects: Turn the suction tube rearwards.(Fig.
2B)
•
Set the container on a sheet of paper, pour in the prepared coating material and screw the
Description (Abb. 1)
Thinning recommendation
2) Nozzle
4) Spray gun front part
6) Spray gun rear part
8) Air filter cover
10) Container
12) Valve
undiluted
undiluted
dilute by 5 - 10%
GB
Beschreibung_GB
Visko
25