Amann Girrbach Ceramill MultiCap Modo De Empleo página 12

U S E R M A N U A L
PlaCIng the holdeR
In the CeRamIll maP
Place the holder in the Ceramill Map the same
way as shown in the Figure.
GB
Figure 7: MultiCap holder in the Ceramill Map
1 MultiCap holder
2 Screw
3 Fixation plate with clamp
4 Spacer plate (optional)
5 Artex scan baseplate
The clamp of the fixation plate
must engage in the bottom section
of the MultiCap holder.
12
1
2
3
4
5
heIght oF the mUltICaP
holdeR In the SCanneR
The MultiCap holder must be positioned with the
aid of the spacer plates, so that the inserted dies
are in the scan focus.
This is at the level of the swivel axis in the
scanner. Refer to the respective instructions for
use of the scanner for this.
Ceramill map400:
To ensure correct positioning, it is recommended
to check the position of the teeth to be scanned
using the measurement range gauge.
Ceramill map300:
To ensure correct positioning, it is recommended
to check the height of the teeth to be scanned in
the region of the rotation axis using the Allen key.
SCannIng / PRoCedURe
After inserting the MultiCap holder in the scan-
ner and starting the scan software, follow the
instructions of the software.
As the dies are fixed in mastic, the
position of the dies should not be altered
before re-scanning. Correct (re-)scanning
can only be guaranteed if the tooth to be
scanned has not been removed from the
holder in the intervening period.