Kobalt SGY-AIR86TZ Manual Del Usuario página 4

SAFETY INFORMATION
Adequate exhaust must be provided to keep air free of flammable vapors.
Do not smoke in or near the work area. Always keep a fire extinguisher present in the
work area.
Always have control of the air hose.
Never spray near sources of ignition such as pilot lights, welders, and etc.
Halogenated hydrocarbon solvents,for example,methylene chloride ,are not chemically
compatible with the aluminum that might be used in many system components. The
chemical reaction caused by these solvents reacting with aluminum can become
dangerous and lead to an equipment explosion.Guns with stainless steel fluid passages
may be used with these solvents. However, aluminum is widely used in other spray
applicationequipment such as material pumps, cups and regulators, valves, and etc.
Check all other equipment items before use and make sure they can also be used
safely with those solvents. Read the label or material safety data sheet for the material
you intend to spray.
If in doubt as to whether or not a coating or cleaning material is compatible, contact you
material supplier for further details.
Operators and maintenance personnel must be physically able to handle the bulk
weight, and power of the tool.
This tool is not intended for using in explosive atmospheres and is not insulated for
contact with electrical power sources.
SOME DUST CREATED BY POWER SANDING, SAWING, GRINDING, DRILLING
AND OTHER RELATED ACTIVITIES CONT AINS CHEMICALS KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER
REPRODUCTIVE HARM. SOME EXAMPLES OF THESE CHEMICALS ARE:
LEAD FROM LEAD - BASED PAINTS
CRSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER MASONRY
PRODUCTS
ARSENIC AND CHROMIUM FROM CHEMICALLY - TREATED LUMBER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON HOW OFTEN
YOU DO THIS TYPE OF WORK. TO REDUCE YOUR EXPOSURE TO THESE
CHEMICALS, WORK IN A WELL VENTIATED AREA , AND WORK WITH
APPROVED SAFETY EQUIPMENTS , SUCH AS THOSE DUST MASKS THAT ARE
SPECIALLY DESIGNED TO FILTER OUT MICROSCOPIC PARTICLES.
Do not remove Brass baffle attached to front of gun body as special technical traning
and tools are required. Only authorized service centers should remove this part.
To avoid cross-threading, all spray gun parts should be screwed in hand tight initially.
If the parts can not easily be turned by hand, be sure you have the correct parts,
unscrew, realign, and try excessive force in matching parts.
WARNING
CAUTION
4