Kobalt SGY-AIR86TZ Manual Del Usuario página 9

REPAIR INSTRUCTIONS
2. Pull out the air distribution ring using a needle-nose pliers,
and remove dirt. (See Figure 5)
NOTE: Make sure that dirt has not settled in the sealing
surfaces and no scratches prevent optimum sealing
performance.
Reconnect air hose with spray gun set to desired PSI.
3. The new air distribution ring must be inserted in a way that the plastic
pin marked with an arrow (1) fits smoothly into the hole marked (2). (See Figure 6)
Then firmly push in the air distribution ring. (See Figure 7) Insert the paint nozzle
and tighten slightly. Then remove it again. Make sure the air distribution ring
fits securely against the gun body.
4. Mount the nozzle set:
a. Screw on paint nozzle.
(See Figure 8)
b. Attach the air cap w/ring.
(See Figure 9)
c. Put on paint needle.
(See Figure 10)
d. Attach the needle spring.
(See Figure 11)
e. Screw on the fluid adjustment
knob. (See Figure 12)
6
2
1
8
10
12
9
5
7
9
11