Cisco Systems Power System 2300 Guía De Instalación De Hardware página 36

Preparing for Installation
To prevent the RPS 2300 from overheating, do not operate it in an area that
Warning
exceeds the maximum recommended ambient temperature. To prevent airflow
restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation
openings. Statement 17B
Before working on equipment that is connected to power lines, remove jewelry
Warning
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals. Statement 43
Warning Blank faceplates and cover panels serve three important functions: they
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 156
Do not reach into a vacant slot or chassis while you install or remove a module
Warning
or a fan. Exposed circuitry could constitute an energy hazard. Statement 206
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity. Statement 1001
Read the installation instructions before connecting the system to the power
Warning
source. Statement 1004
Cisco Redundant Power System 2300 Hardware Installation Guide
2-2
Chapter 2 RPS 2300 Installation
78-17647-02