Tools And Equipment; Installing The Rps 2300 - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Chapter 2 RPS 2300 Installation

Tools and Equipment

Installing the RPS 2300

Note
78-17647-02
Four rubber feet for mounting the RPS 2300 on a table
–
Two mounting brackets (19-inch
–
attaching the brackets to the RPS 2300
Eight Phillips pan head screws for attaching the brackets to a rack
–
The Cisco Redundant Power System 2300 Hardware Installation Guide
•
Warranty manual
•
Product registration card
•
If any item is damaged or missing, notify your authorized Cisco sales
Note
representative.
Obtain these necessary tools and equipment:
Phillips screwdriver to rack-mount the RPS 2300.
•
Ratcheting torque screwdriver with a Number-2 Phillips head that exerts up
•
to 15 pound-force inches (lbf-in.) or 240 ounce-force inches (ozf-in.) of
pressure.
This section describes these installation procedures:
Rack-Mounting, page 2-10
•
Table- or Shelf Mounting, page 2-15
•
If you have questions or need assistance installing the RPS 2300, see the
"Obtaining Documentation, Obtaining Support, and Security Guidelines" section
on page xiv.
Cisco Redundant Power System 2300 Hardware Installation Guide
Installing the RPS 2300
)
and eight Phillips flat-head screws for
2-9