Rack-Mounting - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Installing the RPS 2300

Rack-Mounting

\
Warning
Cisco Redundant Power System 2300 Hardware Installation Guide
2-10
To install the RPS 2300 in a 19-inch rack, follow the instructions described in this
section.
Installation of the RPS 2300 in a 23-inch or 24-inch rack requires an optional
bracket kit not included with the RPS 2300.
To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
To install the RPS 2300 in a rack, you must first remove the screws from the RPS
chassis so that the mounting brackets can be attached. For attachment at the
front-mounting position, remove three Phillips truss-head screws from the RPS
2300 side panels (Figure
remove one screw. For attachment at the rear-mounting position, remove two
screws.
2-1). For attachment at the mid-mounting position,
Chapter 2 RPS 2300 Installation
78-17647-02