Table- Or Shelf Mounting; Connecting The Rps 2300 - Cisco Systems Power System 2300 Guía De Instalación De Hardware

Chapter 2 RPS 2300 Installation

Table- or Shelf Mounting

Caution
Figure 2-4 Mounting the RPS 2300 on a Table or Shelf
100 -240
V
10-5 A AC OK
50-6 0 HZ DC OK
User-supplied screws
1

Connecting the RPS 2300

78-17647-02
To install the RPS 2300 on a table or shelf, locate the adhesive strip with the
rubber feet in the mounting-kit envelope. Attach the four rubber feet to the
recessed areas on the bottom of the chassis.
Remove two Phillips truss-head screws from the switch side panels, and use those
screws to attach the brackets to the RPS 2300
the table or shelf with the appropriate hardware.
Do not use the 19-inch brackets to wall mount the RPS 2300. The brackets are not
suitable for wall mounting.
ST DB Y Re du nd an
/ DC OU TP
AC TIV E t Po we r
1 UT
Sy ste m 23
2
TE MP 3 00
4
5
6
FA N
SE LE CT
ST DB Y/
AC TI VE
2 Phillips truss-head screws
This section provides instructions on connecting the RPS 2300 to a power source
and to external devices. It includes these sections:
Cabling Options, page 2-16
•
Cisco Redundant Power System 2300 Hardware Installation Guide
(Figure
100 -240
V
10-5 A
AC OK
50-6 0 HZ DC OK
Connecting the RPS 2300
2-4). Secure the brackets to
1
2
2-15