Washlet Traditional Lid Installation Manual
● Before installing the Traditional Lid, be sure to read the following installation instructions. Install the product only as described in this manual.
The instructions and illustrations for this section are for the S300, S400 and
Neorest 500 models.
1
Remove the Seat and Original Lid
Raise the seat and original lid. Lift up the seat lock lever (grey) until it
clicks.
Important Point
Lift up on the seat lock lever
until a
is heard.
Click
Lock Lever
Seat Lock Lever
Click
Grasp the seat and lid together at the base. Align the original lid with
the upper edge of the Seat Sensor Window Frame (black). Pull the
seat and orginal lid straight up with both hands.
The seat cord is approximately 2" (5cm). Please do not pull on it
with unnecessary force. (Doing so could damage the seat cord.)
Please do not pull up at an angle or apply excessive force.
(Doing so could damage the unit.)
Important Point
Align the original lid with
the upper edge of the Seat
Sensor Window Frame.
Important Point
Grasp the base of the seat
and original lid with both
hands.
Seat Sensor Window Frame
2
Remove the Original Lid
Place your finger on the seat lock on the right side and move the
hinge toward the inside about 1/4" (5mm).
Remove the orginal lid from the seat
The seat lock and hinge cannot be removed from the toilet seat.
Move toward
the inside
3
Attach the Traditional Lid
Align the traditional lid with the seat from the left side.
Move the hinge on the right towards the outside.
®
Installing the Traditional Lid
Original lid
and seat
Original Lid
Original Lid
Approximately
1/4" (5mm)
Hinge Assembly
3
Attach the Traditional Lid (con't)
4
Attach the Seat and Traditional Lid
Make certain the seat pins are positioned vertically.
For the S300, please use a pair of pliers to move the seat pins
into the vertical position.
For the S400 and Neorest 500, please press the
remote. Wait 10 seconds. Then press the
seat pins into the veritcal position.
Vertical
Position
Seat pin
2
Make certain that the seat lock lever (grey) is up. Align the seat and
traditional lid with the upper edge of the Seat Sensor Window Frame
(black) and press firmly onto the seat pins.
Seat Lock Lever
Click
Important Point
Press on the right and left
sides at the same time.
Seat Sensor Window Frame
3
Lower the seat lock lever (grey) until it clicks into place.
If the lock lever won't go back into place, the seat and traditional
lid will not be attached.
Seat Lock Lever
Click
2011. 1. 31
0GU9205
on the
to move the
Important Point
Be certain to have the
seat pins moved into the
vertical position.
The round mark
Seat pin
should be on top.
Traditional lid
and seat
Traditional lid
and seat