Kit Assembly - Metra 95-9311B Instrucciones De Instalación

1. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
2. Attach the back-up housing to the
radio/bracket assembly with the (4)
#8 x 1/2" Phillips screws supplied.
(Figure B)
3. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio and
climate control panel. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
Note: After all testing has been
performed, disconnect the
climate control panel, relocate
the harness to the lower switch
panel area, and then proceed to
the next step.

Kit Assembly

(Figure A)
(Figure B)
95-9311B
4. Secure the completed assembly
into the radio/climate cavity using
the (2) #8 x 3/8 inch screws
supplied.
5. Secure the vent assembly to the
vehicle using the (2) factory Phillips
screws removed in step 10 of dash
disassembly.
6. Attach (2) panel clips provided
with the kit onto the radio trim
panel (Figure C), and then attach
the panel to the radio assembly.
Secure the assembly to the vehicle
using the (2) factory Phillips
screws removed in step 3 of dash
disassembly.
Continue to climate and switch
panel assembly
5
(Figure C)