Ac Current Measurements - koban KMD-13 Instrucciones Operativas

KMD-13
AUTORANGING MULTIMETER
the circuit.
8. Apply power to the circuit.
9. Read the current in the display. The display will indicate
the proper decimal point, value and symbol.

AC CURRENT MEASUREMENTS

WARNING: To avoid electric shock, do not measure AC
current on any circuit whose voltage exceeds 250V AC.
CAUTION: Do not make current measurements on the
10A scale for longer than 30 seconds. Exceeding 30
seconds may cause damage to the meter and/or the test
leads.
1. Insert the black test lead banana plug into the negative
(COM) jack.
2. For current measurements up to 4000 A AC, set the
function switch to the
lead banana plug into the ( A) jack.
3. For current measurements up to 400mA AC, set the
function switch to the mA range and insert the red test
lead banana plug into the (mA) jack.
20
A position and insert the red test



www.grupotemper.com