Temperature Measurements - koban KMD-13 Instrucciones Operativas

KMD-13
AUTORANGING MULTIMETER

TEMPERATURE MEASUREMENTS

WARNING: To avoid electric shock, disconnect both test
probes from any source of voltage before making a
temperature measurement.
1. If you wish to measure temperature in
switch to the
temperature in
2. Insert the type K thermocouple probe black test lead
banana plug into the negative COM jack and the red test
lead banana plug into the positive Temp jack..
3. Touch the Temperature Probe head to the part whose
temperature you wish to measure. Keep the probe
touching the part under test until the reading stabilizes
(about 30 seconds).
4. Read the temperature in the display. The digital reading
will indicate the proper decimal point and value.
To
WARNING:
thermocouple has been removed before changing to
another measurement function.
26
o
F range. If you wish to measure
o
C, set the function switch to the
avoid electric
o
F, set the function
o
shock, be sure
www.grupotemper.com
C range.
the