Dc Voltage Measurements - koban KMD-13 Instrucciones Operativas

stored value and the measured value.
4. Press the RELATIVE button to return to normal
operation.

DC VOLTAGE MEASUREMENTS

CAUTION: Do not measure DC voltages if a motor on
the circuit is being switched ON or OFF. Large voltage
surges may occur that can damage the meter.
1. Set the function switch to the V DC position ("mV" will
appear in the display).
2. Insert the black test lead banana plug into the negative
(COM) jack and the red test lead banana plug into the
positive (V) jack.
3. Touch the test probe tips to the circuit under test. Be sure
to observe the correct polarity (red lead to positive, black
lead to negative).
4. Read the voltage in the display. The display will
indicate the proper decimal point and value. If the
polarity is reversed, the display will show (-) minus
before the value.
www.grupotemper.com
AUTORANGING MULTIMETER
KMD-13
17