Universal Cutter - Bosch MMB66 Serie Instrucciones De Uso

Instructions for the smoothie insert:
Take measuring cup out of the lid and plug
into the smoothie insert. This prevents
integral components from falling out of the
insert into the drink.
■ Turn blender jug over and put down with
the opening face down.
■ Remove blade holder. To do this, fold
the handle upwards and pull out the
blade holder.
■ Clean all parts, see "Cleaning and
servicing".

Universal cutter

for cutting smaller quantities of meat, hard
cheese, onions, parsley, garlic, fruit and
vegetables.
Pay attention to Figure G in the table!
It is not permitted to cut coffee beans,
pepper corns, sugar, poppy seeds and
horseradish.
Note: If the universal cutter is not
included with the hand blender, it can be
ordered from customer service (order no.
12007111).
W Risk of injury from sharp blades/
rotating drive!
Do not remove or attach universal cutter
until the appliance has been switched off
and the drive has come to a standstill.
Fig. D
■ Put down universal cutter jug with the
opening face up.
■ Add food, which is to be cut, in the
universal cutter.
■ Place seal on the blade holder. Ensure
that the seal is positioned correctly.
Important information
If the seal is damaged or not correctly posi-
tioned, liquid may run out.
■ Grip blade holder by the handle and
insert into the universal cutter jug.
Note shape of the parts (Fig. D-2)!
■ Move handle (Fig. D-3). This locks the
blade holder in the universal cutter jug.
■ Turn universal cutter jug over.
■ Place universal cutter jug on the drive
on the motor block. Arrow on the univer-
sal cutter jug points towards the dot on
the motor block.
■ Attach universal cutter jug by turning it
all the way clockwise.
■ Switch on the appliance: set the rotary
switch to on.
■ Turn rotary switch to Q and hold.
or
■ Press quick selection button V
(depending on model).
Note: The longer the appliance remains
switched on, the finer the ingredients are
cut. In the case of herbs the required cutting
result can be achieved very quickly after
switching the appliance on.
After using the appliance
■ Set the rotary switch to 0/off.
■ Remove mains plug.
■ Remove universal cutter jug by turning
it anti-clockwise.
■ Turn universal cutter jug over.
■ Remove blade holder. To do this, fold
the handle upwards and pull out the
blade holder.
■ Empty universal cutter jug.
■ Remove the rest of the chopped food
from the jug using a suitable implement
(e.g. spoon).
■ Clean all parts, see "Cleaning and
servicing".
Operation en
19