Assembly; Unpacking; Attach Lower Handle; Install The Wheels - Champion Power Equipment 100380 Manual Del Operador

100380 - REAR TINE TILLER

ASSEMBLY

Your tiller requires some assembly. This unit ships from our factory
without oil. It must be properly serviced with fuel and oil before
operation.
If you have any questions regarding the assembly of your tiller, call
our Technical Support Team at 1-877-338-0999. Please have your
serial number and model number available.

Unpacking

1. Remove all parts and packaging components.
2. Remove top lid and remove sides.
3. Remove any remaining packaging.
4. With helper, remove the tiller from the shipping crate.

Attach Lower Handle

1. Loosen the lower handle bolts.
2. Align the lower handle holes to the middle height adjustment
holes in the transmission cover and install the (4) M10×25
mm flange head bolts and (2) M10 nuts. Tighten all hardware.

Install the Wheels

1. Remove the locking pins from the wheel hubs.
2. The tiller wheels are directional. For best performance install
the wheels with the tire thread facing the direction as shown.
3. Slide the wheel hub onto the wheel axle.
4. Align the wheel hub hole with the hole in the axle and insert
the locking pin.
5. Rotate the locking pin ring to lock the pin in position. Repeat
on other wheel.

Install the Tines

Before Assembly
1. Check the orientation of the tine blade. The sharp cutting
edge should be facing the direction of tine rotation for your
tiller.
2. Install the tine assemblies on each tine axle. Secure with (2)
pins and (2) cotter pins. Bend cotter pins once inserted to
prevent them from coming out.

Install the Tine Shield

1. Remove the (4) M8×20 mm flange head bolts installed in the
tine shield brackets above the transmission housing.
2. Place the tine shield on the bracket and secure with the bolts
removed in step 1.
16
ASSEMBLY