Install The Depth Regulator; Attach Upper Handle; Attach Speed Control; Attach Front Bumper - Champion Power Equipment 100380 Manual Del Operador

100380 - REAR TINE TILLER

Install the Depth Regulator

1. Remove the (1) pin and (1) clip from the depth regulator lever.
2. Insert the depth regulator into the bottom of the depth
regulator bracket.
3. Insert the pin through the bracket and lever.
4. Install the clip removed in 1 onto the depth regulator lever.

Attach Upper Handle

1. Slide the upper handle down over the lower handle and align
the holes.
2. Insert the (4) M8×50 curved head bolts into the holes as
shown and securely with the (4) handle knobs and (4) curved
Washer.
3. Tighten the handle knobs securely.

Attach Speed Control

1. Attach speed control using provided (1) M6 bolt, (1) washer,
and (1) M6 nut.
2. Tighten completely.
3. Use plastic clips to secure the cables as shown.

Attach Front Bumper

1. Slide the front bumper onto the outside of the base frame and
align the holes.
2. Install the (4) M8×20 mm bolts and (4) M8 lock nuts and
tighten securely.
Before operating your machine, carefully read and understand
all safety, controls and operating instructions.
Failure to follow these instructions can result in serious
personal injury.
17
ASSEMBLY
WARNING
