Reverse Lever; Depth Regulator Lever Adjustment - Champion Power Equipment 100380 Manual Del Operador

100380 - REAR TINE TILLER

Never pull the tiller toward you with the tines engaged.

Reverse Lever

The reverse lever controls the reverse motion of the wheels
and forward motion of the tines. To operate the Reverse
Lever:
1. Put wheels in WHEEL DRIVE position (see "WARNING"
statement).
2. Ensure all tiller tine motion has stopped before re-engaging
tines.
3. Depress and hold the lever against the handlebar to start the
wheels in reverse and tines rotating in a forward direction.
4. Release the lever to disengage (stop) the wheels and tines
(the engine will continue to run).

DO NOT till in reverse.
WARNING
WARNING

Depth Regulator Lever Adjustment

This regulator lever controls the tilling depth of the tines. Remove
pin and clip and slide regulator lever up or down as required.
Reassemble pin and clip.
The "travel position" (highest hole) raises the tines approximately
1-1/2 in. (4 cm) off the ground, allowing the tiller to be moved
without the tines contacting the ground. This setting should also
be used when starting the engine.
Moving the regulator lever upward will increase the tilling depth.
The lowest notch allows a tilling depth of approximately 6 in. (15
cm), depending on soil conditions. For best results, always begin
tilling at a very shallow depth setting and gradually increase the
tilling depth.
Do not attempt to till too deeply too quickly.
Gradually work down to deeper tilling depths.
Place the Depth Regulator Lever in the "travel" position before
starting the engine. This position prevents the tines from
touching the ground until you are ready to begin tilling.
Failure to follow this warning could result in personal injury or
property damage.
19
ASSEMBLY
WARNING
