Changing The Signal Duration; Care And Cleaning - Siemens iQ100 Instrucciones De Uso

Cancelling the setting

Changing the signal duration

Care and cleaning

Press stop twice or open the appliance door and
press stop once.
You will hear a signal when the appliance is switched
off. You can change the duration of the acoustic
signal.
Press Start for approximately 6 seconds.
The new signal duration is adopted. The clock
reappears in the display.
The following are possible:
Short signal duration - 3 tones
Long signal duration - 30 tones.
d
There is a risk of a short circuit.
Do not use high pressure cleaners or steam jets.
d
There is a risk of electric shock.
Do not immerse the appliance in water or clean under
a jet of water.
d
Risk of burning.
Do not clean the appliance immediately after
switching it off. Allow the appliance to cool down.
Do not use sharp or abrasive cleaning agents. The
surface could be damaged. If an abrasive substance
comes into contact with the front of the appliance,
wash it off immediately with water.
q Do not use metal or glass scrapers to clean the
glass in the appliance door.
q Do not use metal or glass scrapers to clean the
seal.
113