Kit Assembly - Metra 99-5828CH Instrucciones De Instalación

ISO DIN head unit provisions
1. Attach the provided clips to the posts on
either side of the hazard assembly on the
back of the radio trim panel. The factory
clips may be used if desired.
2. Attach the a/c vents to the radio trim
panel using the supplied (2) #4 x 1/2"
Phillips screws.
3. Attach the factory display to the radio
trim panel using the supplied
(4) #8 x 3/8" Phillips screws. (Figure A)
4. Mount the pocket to the radio brackets
with the (4) #8 x 3/8" Phillips pan head
screws supplied. (Figure )
5. Slide the radio into radio brackets and
secure with the screws supplied with the
radio. (Figure B)
6. Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter from Metra or AXXESS.
Re-connect the negative battery terminal
and test the unit for proper operation.
7. Mount the new radio assembly into the dash,
snap-in the radio trim panel, and reassemble
dash in reverse order of disassembly.
99-5828CH

Kit Assembly

(Figure A)
(Figure B)
Double DIN head unit provisions
1. Attach the provided clips to the posts on
either side of the hazard assembly on the
back of the radio trim panel. The factory
clips may be used if desired.
2. Attach the a/c vents to the radio trim
panel using the supplied (2) #4 x 1/2"
Phillips screws.
3. Attach the factory display to the radio
trim panel using the supplied (4) #8 x
3/8" Phillips screws. (Figure A)
4. Mount the DDIN radio to the radio
brackets using the screws supplied
with the radio. (Figure B)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
6. Mount the new radio assembly into the
dash, snap-in the radio trim panel, and
reassemble dash in reverse order of
disassembly.
3
(Figure A)
(Figure B)
Continued on back