Kit Preparation; Kit Assembly - Metra 95-5703B Instrucciones De Instalación

KIT PREPARATION

To the 95-5703B radio trim panel:
1. Attach the factory a/c vents removed in
Dash Disassembly to the vent housing.
(Figure A)
2. Attach the vent housing. (Figure B)
3. Attach the (4) panel clips provided.
(Figure B)
Attention! The factory trim panel will not be
able to be reinstalled once the following
step is performed.
4. Cut the sub-dash to allow room for the
radio assembly. (Figure C)
Continue to Kit Assembly
(Figure A)
(Figure B)
Remove shaded areas
(Figure C)

KIT ASSEMBLY

1. Secure the radio brackets to the radio using
the screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to the
radio. Metra recommends using the proper
mating adapter from Metra. Test the radio
for proper operation.
3. Remove (2) T-20 Torx screws securing the
bottom of the climate control panel. Slide
the radio assembly into the dash, then
secure it using the climate control screws,
and also the (4) 1/2" screws provided. It
would be best if the 1/2" screw holes were
pre-drilled with a 1/8" drill bit to avoid the
plastic from cracking. (Figure B)
4. Attach the radio trim panel assembly to the
dash and radio brackets.
5. Clip the shifter trim panel back to the
vehicle to complete the installation.
(Figure A)
(Figure B)
REV. 7/19/2021 INST95-5703B
3