Using Humidifiers - ResMed S8 Elite Manual Clínico

338210r3 Eng.book Page 17 Monday, July 11, 2005 1:28 PM
Table 1: Star ratings for the mask-fit and patient Smart Data features
Star rating
* * * * * (Excellent)
* * * * _ (Very good)
* * * _ _ (Good)
* * _ _ _ (Adjust mask)
* _ _ _ _ (Adjust mask)
_ _ _ _ _ (Adjust mask)
Note: While using the mask-fit feature, the star rating values correspond are indicative of
the instantaneous leak calculated over the last 10 seconds.
Smart Data (designed for the patient) also uses a star rating for mask fit. The Smart Data
star rating values correspond to 70th centile mask leak for the last session. A five-star
rating is displayed, for example, if the leak rate was less than 0.10 L/s for 70% of the
session.
5
After three minutes, the pressure will revert to the set pressure, and treatment will
begin.
If you do not wish to wait three minutes, hold down the Start/Stop key for three
•
seconds and treatment will begin immediately.
If you press the Start/Stop key briefly (ie, for less than three seconds), the device
•
will return to standby mode (the RAMP screen is displayed).
U H
SING UMIDIFIERS
Please refer to the illustration in section E of the illustration sheet, and your HumidAire 3i
manual.
The
H A
UMID IRE
humidification. No other accessories are required for its use
Notes:
a. Make sure the water chamber of the HumidAire 3i is empty before you attach or
detach the humidifier.
b. Remove the connector plug on the S8 Elite before you attach the HumidAire 3i.
Reattach the connector plug firmly after you detach the humidifier.
S H
TORING THE
Store the
H
UMID
Indicative Leak Measure
(L/s)
0.00–0.18
0.19–0.26
0.27–0.34
0.35–0.41
0.42–0.49
≥
0.50
attaches to the front of the
3i
A 3
UMID IRE
i
in the larger, mesh-top pouch when not in use.
A 3i
IRE
(L/min)
0.0–10.8
10.9–15.6
15.7–20.4
20.5–24.6
24.7–29.9
≥
30
to provide heated
S8 E
LITE
.
O I
PERATING NFORMATION
17