Angelo Po 191BR1GA Manual De Uso E Instalación página 68

3 - Unscrew the screw (C).
4 - Undo the screws (D) to remove the support (E).
5 - Extract the gear motor and its components.
6 - If necessary, replace the gear motor (F), the
support (G), the gasket (H), the rotation stop
device (L) and the bearing (M).
7 - Undo the screws (N) and remove the bushes
(P).
8 - Unscrew and replace the threaded rod
(Q).
9 - Set the bush (R) at the distance as shown
in the figure.
10 - Reassemble the bushes (P) and tighten the
screws (N).
Important
Lubricate the threaded rod (Q) with Teflon
grease (Tecnolube Seal RHEOLUBE 368F,
IT
OKS 265, etc.).
11 - Reassemble the gear motor (F) and its compo-
GB
nents.
12 - Reassemble the lid (E) and secure it with the
DE
screws provided.
13 - Fit the screw (C) and tighten it.
FR
14 - Replace the control panel (B) on completion of
the operation.
ES
DECOMMISSIONING THE APPLIANCE
Important
This operation must be carried out by
skilled operatives in compliance with the le-
gal requirements with regard to safety at
work. Never dump non-biodegradable ma-
terials, lubricating oils and non-metallic
English
F H L
C
N Q
P
components (rubber, PVC, resins, etc.) in
the environment. Dispose of them in ac-
cordance with the relevant legal require-
ments.
- 32 -
G
M
D E
IDM-39616201900.tif
N
P
IDM-39616202000.tif
R