GLOBBER ONE K 180 Manual De Instrucciones página 4

CLASS A 100KG MAX
Keep the instructions for future.
NF-EN-14619
READ THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER BEFORE USING.
MAXIMUM WEIGHT: 100 KG
Warnings
- The scooter is reserved for adolescents and adults. It is not a toy, but sports equipment for
physical training, it is not intended for use in extreme sports such as jumping, ollie ramps, etc. This
product should never be used at a skate park for an "aggressive" use (challenging skateboarding
moves, etc.).
- U se with caution on a flat, clean, dry surface and, if possible, away from other users, and obey
the road safety rules.
- C heck local laws regarding scooter use, respect all the traffic rules and signs. Stay away from
other pedestrians or users on public roads.
- B est when used on a flat, dry surface free of gravel and grease. Avoid bumps and drainage grates
that might cause an accident.
- Warning! Protective equipment consisting of wrist protectors, gloves, knee pads, helmets and
elbow pads should be worn.
Using the scooter
• Before and after each use: To prevent pinched fingers, carefully follow the instructions of
unfolding and folding. Make sure that the locking mechanisms are securely locked:
- Check the height of the steering system and make sure that the nuts are tightened and the
handlebars and front wheel are perpendicular.
- Check all connected elements; the brake and the wheel axles must be correctely adjusted, and
must not be damaged.
- Also check the tire wear.
• During use:
- Standing on the scooter, with one hand on each handle, push with one of your feet to move
forward. Proceed with caution at the start.
- Shoes are mandatory and we strongly recommend wearing pants and long sleeve shirts to avoid
injury if you fall.
- The scooter does not include any headlights or lights. It is therefore not suitable for use at night or
during periods when visibility is limited.
• Braking:
- A brake is located at the rear, when necessary, press down on it to slow down. Press down
gradually to prevent skidding or loss of stability. The metal or aluminum brake may heat up after
multiple uses. Avoid touching it during and after use.
- If model with the handlebar brake: a right brake handle to slow the front wheel. When using, keep
riding the scooter with both hands.
- Pressing the brake lever and push the brake lock button down.
The brake lock button allows you to lock the front wheel for storage in vertical static position
(unblocking by pressing the brake).
Assembling the product
- The folding and unfolding operations of the scooter are to be done by a single person.
- D uring these operations, be careful you do not get your fingers stuck in the hinge and locking
4
system.
- Make sure that the locking devices are properly engaged.
Warning! Risk of injury by pinching!
Do not insert your fingers into the shaded area indicated in the image.
1 - Unfold the scooter
Step 1: Hold the scooter upright, one hand holding the handle and the other hand pulls the platform
downwards until it clicks lock as shown in the drawing A.
Step 2: Take the hex wrench out of the box. Unscrew the 2 screws from the fixing lug, please pay
attention and do not lose the washers. Place the middle of the handlebar (stripes engraved on the
handlebar) into the fixing lug with the brake on the right. For ONE K ACTIVE models (498), place
the two protective rubber covers on either side of the fixing lug. First, put the washers in place
and then tighten the screws but not fully, allowing you to rotate the handlebar to adjust it at your
convenience. Finally, screw the nuts really tight.