ONE K 180
ONE K ACTIVE
2 - Folding the scooter
Both hands on the handlebars, giving a slight kick pedal lock as shown in the drawing B, fold
the handlebars to the ground, the platform goes back only in the folded position, as shown in the
drawing C.
DO NOT FORGET TO REGULARLY TIGHTEN THE DIRECTION BLOCKS TO AVOID
MISALIGNMENT OR LOSS OF THE SCREW.
Care / Maintenance: regular maintenance is a safety commitment;
- Wheel bearings: avoid going through water, oil or sand as this can damage wheel bearings. To
look after the wheel bearings, systematically check that the wheels turn properly by turning the
scooter upside-down and using your hand to spin the wheels. If the wheels do not spin they must
be removed to check their condition. First unscrew the wheel axle, remove the axle and detach
the wheel, then carefully push the two wheel bearings out of their housing. If they are chipped or
dented, new ones should be bought. If there is no visible damage, they must then be oiled. To do
this, remove all traces of grease, mud or dust with a kitchen towel or cloth, and re-oil them with a
grease spray or by leaving them to soak overnight in oil [turn them several times in the oil first].
Then reassemble the wheel bearings and axles, followed by the wheel, onto the scooter. Proceed
in the same manner for the other wheel.
- Wheels: the wheels wear down with time if overly used on rough surfaces. In the interest of safety,
they should be checked regularly and replaced if necessary.
- Modifications: the original product must by no means be modified except for the maintenance-re-
lated changes mentioned in these instructions.
- Nuts, axles and other self-locking fixings: these should also be checked regularly. They can
become loose after a while in which case they should be tightened. They can become worn and
not tighten properly, in which case they should be replaced.
Below features are for ONE K ACTIVE (498) only.
ONE K ACTIVE has a 3-height adjustable handlebar (91 - 101cm /35.83 -39.8) to easily adapt to the
user's height.
ONE K ACTIVE models have a piston folding system. When you kick the mechanism on the bottom of
the pole to fold the scooter, the back wheel will automatically lift up, to put the scooter in trolley mode.
5