Nederman High Vacuum Starter Manual De Instrucciones página 25

SIEMENS
TD 200
WEEK TIMER (WT) 2
Off=0 On=1 Setting=2
SHIFT ESC
Press
SIEMENS TD 200
Monday 1 700 1700
Monday 2 -1 -1
SHIFT ESC
In the example below 1st start is
07.00 and 1st stop is 11.45
2nd start is 12.30 and 2nd
stop is 17.00
SIEMENS
TD 200
Monday 1 700 1145
Monday 2 1230 1700
SHIFT ESC
Down-arrow flashes when the last setting for Monday has been confirmed
Press
SIEMENS TD 200
Press SHIFT+F5
to enter next day
On
Standby
F5
SHIFT ESC
Down-arrow flashes when last setting for Sunday has been confirmed
Press
SIEMENS
TD 200
Press SHIFT+F5
to exit settings
On
Standby
F5
SHIFT ESC
NOTE!
an indefinable time that time will not be processed by the program. Thus, at a stopping
time entered like "1765" the installation will not stop. It will not stop until next (correct)
stopping time.
SIEMENS
Press SHIFT+F5
to enter Monday etc
On
Standby
F5
ENTER
Press to select 1:st start time on
ENTER
Monday 1.
(Default time is 700,
i.e. 07.00)
Press to confirm 1:st start
ENTER
time and automatically select 1:st
ENTER
stop time. (Default 1:st stop time is
17.00.)
Press to confirm and proceed to
ENTER
2:nd start time, Monday 2.
(Default value -1 means that no time
has been entered.)
Press to confirm and and go to
ENTER
2:nd stop time. (Default value -1
means that no time has been en-
tered.)
By pressing repeatedly at this point the program loops through Monday
ENTER
settings and changes can be made, if reqired.
ENTER
Press SHIFT + F5 to enter next day. Pressing SHIFT + F5 repeatedly causes the
program to jump to following days. Enter settings for remaining week days. If
the installation is not supposed to run on Saturdays & Sundays enter setting -1
(default setting). However, see Chapter 'Activating default settings'.
ENTER
Pressing SHIFT + F5 at this point makes the program return to the starting
point 0 and the week timer automatically sets itself to code figure 1, i.e.
the week timer is active. If required, return to week timer menu (11) and enter
code figure 0. Entered week timer settings are unaffected but the week timer is
not active. Setting to code figure 1 makes the week timer active again.
ENTER
The week timer program accepts time settings like "1765" But since "17.65" is
High Vacuum Starter, Advanced
Press Shift + F5 to
TD 200
enter Monday
SHIFT ESC ENTER
Forwards
Backwards
Forwards
Backwards
Forwards
Backwards
Forwards
Backwards
EN
25