Tabla de contenido
Publicidad
Place the upper section on the container and close the side
latches.
(* depending on the equipment variant)
5.4 Insert PE emptying and disposal bag*
Only the vacuum cleaners class M and H with special containers
and rotary slider in the suction aperture of types ISP iPulse ARM,
ISP iPulse ARH and ISP iPulse ARH-Asbestos are suitable for
the use of PE Emptying and disposal bags.
Operating the rotary slider*
Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
Place the rotary slider* in the suction aperture with the mark ●
pointing upwards.
Slide the lange completely over the suction aperture and place
the upper bag opening over the edge of the container.
Place the upper section on the container and close the side
latches.
(* depending on the equipment variant)
6 Changing the ilter
6.1 Changing the folding ilter
(See short-form instructions
Shake the folding ilter cassettes before changing them.
24 - GB
NOTE
NOTE
)
Turn the lock on the latch through 90° in a counter-clockwise
direction with a coin or similar object and push the latch to the
rear.
Fold the hood up
Immediately isolate the folding ilter cassettes that you have
removed in a dust-tight plastic bag and dispose of properly in
accordance with the stipulations.
Insert new folding ilter cassettes.
Lift the locking bracket up, fold the hood down and click in place
with light pressure.
7 Changing the motor protection ilter
(See short-form instructions
If the motor protection ilter is contaminated this indicates defec-
tive ilter cassettes.
Replacing the folding ilter cassettes.
Replace the motor protection ilter or wash the motor
protection ilter under lowing water, dry and re-insert..
8 Transport
Insert the closing plug* of the vacuum cleaner into the suction
aperture.
The motor head must be securely ixed to the container (close
the latches).
Place the accessories in a suitable plastic bag and seal the plas-
tic bag or place it in the tool storage compartment.
Plug the ends of the suction hose into each other.
Place the hose around the vacuum cleaner and clamp onto the
handle (see short-form instructions).
9 Maintenance
Switch the vacuum cleaner off and pull out the mains plug before
any maintenance work.
For maintenance by the user, the vacuum cleaner must be
- dismantled,
- cleaned and
- maintained,
as far as possible without creating any danger to the maintenance
personnel or other.
Precautionary measures
Suitable precautionary measures include
- Cleaning before dismantling,
- Provide local iltered positive ventilation where the vacuum
cleaner is to be dismantled,
- Clean the maintenance area and
- suitable personal protection equipment.
Precautionary measures with vacuum cleaners class H and M
The outside of the vacuum cleaner should be cleaned and wiped
down or should be treated with a sealing agent before being
)
NOTE
NOTE
Publicidad
Tabla de contenido
