Emptying The Container - Starmix ISP iPulse AR L-1435 Instrucciones Para El Manejo

Ocultar thumbs Ver también para ISP iPulse AR L-1435:
Tabla de contenido

Publicidad

Remove the suction hose from the liquid before emptying.
After switching off, a small quantity of water can low back out of
the hose, as a result of the high suction level and the favourable
low condition in the container.
If you use it as a dry vacuum cleaner, you must insert dry ilters.
If you change between dry and wet vacuum cleaning frequently,
we recommend using a second set of ilters, preferably polyester
folding ilter cassettes.
4 Permanent ilter cleaning
The vacuum cleaner is itted with an electromagnetic
ilter cleaning unit which can be used to shake the
dust off the folding ilter cassettes.
The folding ilter cassettes are cleaned alternately
so that continuous working can be guaranteed.
- Continuous monitoring of the ilter illing level through differential
pressure measurement, for an absolutely precise on-demand
ilter cleaning during the operation
- Thereby constant high air low cleaning guaranteed during the
operation, even for critical types of dust
dif. = 0
dif. = max.
NOTE

5 Emptying the container

Only permitted for dust with AGW's > 1mg/m
Switch the vacuum cleaner off, pull the mains plug out.
Open the latches.
Remove the cover and suction hose from the container.
Empty the container by pouring out.
5.1 Dispose of the leece ilter bag
Pull the mains plug out (see short-form instructions
Fit mouth protection.
Remove suction hose, close off the suction spigot with a plug*.
Open the side latches, remove the top section.
Carefully pull the lange off the suction spigot and close off the
lange.
Dispose of the vacuumed up material in accordance with legal
requirements.
5.2 Dispose of the PE emptying and disposal bag
PE emptying and disposal bag: Switch the vacuum cleaner on,
shake the folding ilter cassettes. Switch off the vacuum cleaner
(see short-form instructions
Fit mouth protection.
Remove suction hose, close off the suction spigot with a plug*.
Open the side latches, remove the top section.
Before setting aside the top section, switch to >IR< position, to
draw up any loating dust which may exist.
Close off the PE emptying and disposal bag carefully with the
tape provided.
Carefully pull the lange off the suction spigot and close it off
Remove the PE emptying and disposal bag carefully from the
container
Dispose of the vacuumed up material in accordance with legal
requirements.
5.3 Insert leece ilter bag
Only use leece ilter bags for dry vacuum cleaning.
Slide the lange completely over the suction aperture (see short-
).
form instructions
Operating the rotary slider*
Push the rotary slider* from the inside to the outside, turn
through 180° (see mark) and then push inwards again from
the outside through the suction spigot
Place the rotary slider* in the suction aperture with the mark
▲ pointing upwards.
NOTE
3
).
).
NOTE
NOTE
GB - 23

Publicidad

Tabla de contenido
loading

Tabla de contenido