Copy Functions Explained - Danfoss TP9000 Guia Del Usuario

Programming "B" programme days and events
a) Press DAY/HOL until the fi rst preset time
and temperature (Event 1 for Programme B)
appears in the display.
b) Use the + and - buttons to adjust the TIME (press and hold to
change in 10 minute increments).
c) Use the Λ and V buttons to adjust the required TEMPERATURE
(CH only).
d) Press NEXT to move to the next preset time and/or temperature
(Event 2).
e) Repeat steps b, c, & d to programme the remaining events.
Running the programme
Press PROG to return to previous RUN mode.
The Heating will now follow the times and
temperatures programmed.

1.5 Copy functions explained

There are 2 possible copy functions available. These are; Standard
Copy and Enhanced Copy. Copy functions are enabled/disabled in
the Advanced Programming Options (page 20)
Standard Copy: Pressing copy will copy the previous days events
into the displayed day. The unit will then display the 1st event for the
new day. This copy function is present only if the unit is set to run in
5+2 or 7 day mode.
Enhanced copy: The enhanced copy function is available in 7 day
mode only. This allows any day to be copied to any other day, or days.
To use the enhanced copy function, go into the event programming
using the PROG button, then:
1) use the DAY button to fi nd the day to be copied from
2) press the COPY button to select the day to be copied
from. When selected, the day should begin to fl ash.
3) use the DAY button to fi nd the day to be copied to
4) press COPY button to copy the selected day
Danfoss Heating
All manuals and user guides at all-guides.com
GB GB
PL
GR
ES
13