Preset Programmes (Ch/Hw); Central Heating; Hot Water - Danfoss TP9000 Guia Del Usuario

When programming the TP9000 it is important to be aware of which
mode is active before beginning programming. To toggle between
modes, press the CH/HW button. The display will change and the
indicator bar at the bottom will move to refl ect which mode is
selected. The fl ame ( ) and tap ( ) symbols are used in conjunction
with the LED's to show the current output status (on/off ). The output
status is always shown for both Heating and Hot Water regardless of
the display mode.
1.2 Preset programmes
Your TP9000 comes ready programmed with a set of operating times
and temperatures which suit most people. Please remember that
some of the options available will depend on how the installer has set
up the unit.

Central Heating

Weekdays (Mon-Fri)
Event Time
1 06:30
2 08:30
3 11:30
4 13:30
5 16:30
6 22:30
Note: these are also times for
Block "A" programmes

Hot Water

Weekdays (Mon-Fri)
Event Time
1 06:30
2 08:30
3 11:30
4 13:30
5 16:30
6 22:30
Note: these are also times for
Block "A" programmes
Danfoss Heating
All manuals and user guides at all-guides.com
Temp. °C Event
20
15
20
15
21
15
Note: these are also times for
Temp. °C Event
On
Off
On
Off
On
Off
Note: these are also times for
Weekend (Sat-Sun)
Time Temp. °C
1 07:30
2 09:30
3 11:30
4 13:30
5 16:30
6 22:30
Block "B" programmes
Weekend (Sat-Sun)
Time Temp. °C
1 07:30
2 09:30
3 11:30
4 13:30
5 16:30
6 22:30
Block "B" programmes
GB GB
PL
GR
ES
20
20
20
20
21
15
On
Off
On
Off
On
Off
7