Setting the correct time
After setting the date press PROG to display the
time. The time display will fl ash on and off .
Use the + and - buttons to set the correct
time (press and hold to change in 10 min.
increments).
Setting the correct day
The day of the week is set automatically. Press
PROG to return to normal operation (RUN).
Accepting the preset programmes
If you are happy with the preset times shown in the table on page 7
you need take no further action.
1.4 Changing the preset programmes
Before you change the preset programmes
Your installer will have set the unit to operate in one of the following
modes:
•
7 day - each day has independent times and temperatures off ering
full fl exibility of programming (page 10).
•
5/2 day - one set of programmes for weekdays and another for
weekends (page 10).
•
24 hr - one set of programmes for the whole of the week (page
11).
Alternatively
•
A/B - The unit can also be set by you to provide two programme
blocks, either of which can be applied to diff erent days of
the week. If this is required refer to option 1 on page 20 for
instructions on how to turn on this feature.
Please Note
The unit must be programmed in sequence, event times cannot
be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT to
move to the next setting.
D
D
Danfoss Heating
D
D
D
D
D
a
a
a
n
n
n
f
f
f
f
f
f
f
f
o
o
o
s
s
s
s
s
s
H
H
H
H
H
H
e
e
e
a
a
a
t
t
t
t
t
i
i
i
i
i
i
i
n
n
n
g g
g
g
g
All manuals and user guides at all-guides.com
GB
GB
PL
GR
ES
9
9