Bosch SCT 815 Manual Original página 19

1
2
 18: Positioning the mount for the laser range finder
(1) Mount for laser range finder
(2) Prismatic reflector
4. Insert the laser range finder
vertical tray .
 19(2)
1
3
2
4
 19: Inserting the laser range finder
(1) Laser range finder
(2) Vertical tray
(3) Spirit level on the prismatic reflector
(4) Positioning foot
5. Use the positioning foot
on the prismatic reflector
SCT 815.
 WARNING – severe eye damage from laser beam.
Robert Bosch GmbH
1
 19(1) into the
1
3
2
and the spirit level
 19(4)
to level the
 19(3)
6. Never look directly into the laser source.
7. To test function, hold an object in front of the exit
point of the laser range finder.
8. Switch on the laser range finder.
 The laser range finder indicates the current
distance between the prismatic reflector and the
ground.
 CAUTION – risk of crushing when adjusting the
height of the prismatic reflector.
9. Do not place fingers between the tool holder and
the guide tubes.
10. Loosen the knurled screw
holder until the height of the prismatic reflector can
be adjusted.
1
 20: Adjusting the height of the prismatic reflector
(1) Knurled screw
11. Use the laser range finder to position the prismatic
reflector at the precise specified vehicle-specific
height.
— If the vehicle rests on a lift or leveling surface,
measure the difference in height and add it to
the vehicle-specific height.
12. Use the knurled screw to secure the tool holder.
---Separator---
4.6 Setting the offset (up to 25cm) from the
vehicle's longitudinal center plane
The offset of the prismatic reflector from the vehicle's
longitudinal center plane is specified in the
corresponding brief instructions. The offset specific to
the vehicle is found in the column with the following
pictogram.
Operation | SCT 815 | 19 | en
 20(1) on the tool
1 689 989 362 | 2018-08-01