Spare Parts - Bosch SCT 815 Manual Original

en | 20 | SCT 815 | Maintenance
 21: Pictogram for the offset of the prismatic reflector
The SCT 815 must be aligned with the vehicle's
longitudinal center plane.
1. Use the corresponding brief instructions.
2. Look up the offset of the SCT 815 for the relevant
vehicle.
3. Use the ruler on the tool holder
offset of the prismatic reflector.
2
 22: Setting an offset of up to 25 cm
(1) Ruler on the tool holder
(2) Arrow on the prismatic reflector for precise offset setting
---Separator---
4.7 Setting the offset (25cm and above)
from the vehicle's longitudinal center
plane
The offset of the prismatic reflector from the vehicle's
longitudinal center plane is specified in the
corresponding brief instructions. The offset specific to
the vehicle is found in the column with the following
pictogram.
 23: Pictogram for the offset of the prismatic reflector
The SCT 815 must be aligned with the vehicle's
longitudinal center plane.
1. Use the corresponding brief instructions.
2. Look up the offset of the SCT 815 for the relevant
vehicle.
 WARNING – severe eye damage from laser beam.
3. Never look directly into the laser source.
4. To test function, hold an object in front of the line
laser exit point.
5. Align the SCT 815 with the vehicle's longitudinal
center plane. Aligning the
with the vehicle's longitudinal center plane"
6. Draw two auxiliary lines
specified offset at right angles to the projected laser
line .
 24(1)
1 689 989 362 | 2018-08-01
 22(1) to set the
1
 18 "Aligning the SCT 815
of the length of the
 24(2)
7. Use the two auxiliary lines to draw a line parallel to
the projected laser line.
8. Move the SCT 815 until the projected laser line of
the line laser converges with the drawn parallel line.
1
2 2
3
 24: Setting an offset of 25 cm or above
(1) Laser line on the vehicle's longitudinal center plane
(2) Auxiliary lines
(3) Laser line adjusted by the offset
---Separator---
5. Maintenance
5.1 Cleaning
 Use only neutral cleaning agents and soft cloth to
clean the SCT 815.
Coarse workshop rags and abrasive cleaning
agents may damage the SCT 815 .
---Separator---

5.2 Spare parts

Designation
<)
Prismatic reflector
Mount for laser range finder
Laser range finder GLM 20
Line laser P-Assist S5
Positioning foot parts set
<) ---Separator---
Wearing part
---Separator---
5.3 Changing the positioning foot
1. Remove the defective positioning foot.
2. Use a positioning foot from the spare parts set.
3. Thread the thread of the lower part of the
positioning foot
 25(3)
base plate.
4. Screw the nut onto the thread.
 25(2)
5. Screw the knurled screw of the positioning foot
onto the thread all the way to the stop.
 25(1)
6. Lock the knurled screw with the nut previously
screwed onto the thread.
Part number
1 685 350 017
1 680 423 011
1 687 010 600
1 690 381 124
1 687 010 599
through the hole on the
Robert Bosch GmbH