Sirius S900 Instrucciones De Uso Y De Montaje página 12

WARNINGS
Before installing the appliance, make sure
that none of the parts is damaged in any way.
In case of damaged parts, contact your retai-
ler and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
* The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with
the appliance.
* The cooker surface and the inferior part
of the cooker hood must be at a minimun
distance of 65 cm.
* The air sucked can't be conveyed throu-
gh or into a duct used to let out fumes
from appliances fed by energy other than
electric power (eg. centralized heating, ra-
diators, water-heaters, etc.).
* To evacuate the air outlet, please comply
with the pertaining rules given by compe-
tent authorities.
* Provide the room with an adequate aeration
when a cooker hood and appliances fed by
energy other than electric power (gas-, oil-,
or coal- stoves, etc.) are used simultaneously.
The cooker hood, when evacuating the sucked
air, could generate a negative pressure in the
room- which can't exceed the limit of 0.04
mbar, in order to avoid the suck of exhausts
deriving from the heat-source. Therefore the
room should be provided with air-intakes to
allow a costant flow of fresh air.
If the rating lable in the cooker-hood
shows the symbol
built in class II° and it does not need any
earth connection.
, the appliance is
If the rating lable in the cooker-hood does
not show the symbol
built in class I° and it needs the earth con-
nection.
* When performing the electrical connections on
the appliance, please make sure that the current-
tap is provided with earth connection and that
voltage values correspond to those indicated on
the label placed inside the appliance itself.
* Before carrying out any cleaning or main-
taining operations, the appliance needs to
be removed from the electric grid. If the ap-
pliance is not provided with a non-separable
flexible cable and plug, or with another de-
vice ensuring omnipolar disconnections from
the grid, with an opening distance between
the contacts of at least 3 mm, then such di-
sconnecting devices must be supplied within
the fixed installation.
If the fixed appliance is endowed with a sup-
ply cord and a plug, the appliance has to be
put in a place where the plug can be reached
easily.
* The use of materials which can burst into
flames should be avoided in close proxi-
mity of the appliance. When frying, plea-
se pay particular attention to fire risk due
to oil grease. Being highly inflammable,
fried oil is especially dangerous. Do not
use uncovered electric grills. In order to
avoid possible fire risk, all instructions
for grase-filter cleaning and for removing
eventual grease deposits should be strictly
followed.
12
, the appliance is