Sirius S900 Instrucciones De Uso Y De Montaje página 16

MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter pa-
nel. It can be removed by pushing its special
handle toward the back-side of the cooker
hood and turning the filter downwards so to
unfasten it from its slot (Fig.3).
To insert the filter just perform the opposite
operation.
After 30 hours working (model), the push
button control panel will signal the saturation
of the grease filter by lighting all the buttons.
Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig.7) needs to
be periodically replaced. The coal filter can
be removed by removing the grease filter
first (Fig.3), and by pulling its special plastic
tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the
opposite way. The coal filter needs replacing
depending on the use, but however every six
months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
* To replace the halogen lamps, remove first
the glass-blocking ring (Fig.8A), by levering
with a screw-driver and thus removing the
opaque glass (Fig.8B) - when performing this
operation hold the opaque glass carefully.
Remove the lamp (Fig.8C) without touching
it with uncovered hands. Replace it with ano-
ther lamp of the same kind. After the repla-
cement, re-insert the glass-blocking ring and
fasten it.
To replace the round or square LED lamps,
you have to check first if it is possible to ac-
cess the back side of the lamp with your hand
(Pic. 12).
If it is possible to access the back side of the
lamp, you have to: insert your hand , push
at the same time both support wings of the
lamp (Pic. 13), push to remove the lamp (Pic.
14).
If it is not possible to access the back side of
the lamp, you have to: provide yourself with
a sharp utensil, insert the utensil between the
lamp and the stainless steel frame (on the
side where the little support wings are pla-
ced), push to remove the lamp from the coo-
ker hood (Pic. 15).
* Warning! To take down the appliance from
the cabinet, remove the definitive fixing
screws (fig. 6) using a screw-driver, get off
.
the grease filters (fig.3B) and the active car-
bon filters, if they are inserted (fig. 7A). Act
on the small handle of the springs, which are
inside the built-in unit, with the necessary
strength to unhook the appliance from the
cabinet.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
16